成人亚洲精品久久久久,岛国av动作片在线观看

TranslationMobile

標定系數
標定因子
刻度系數
校準因數
校準因子

"calibration" in Chinese : n. 1.測定口徑。 2.刻度，標度，劃度數。 3.校準 ...
"factor" in Chinese : n. 1.〔英國〕經銷人；(代客買賣收取傭金的)經紀人； ...
"calibration factor of a data channel" in Chinese : 數據通道校正系數
"calibration factor of the primary device" in Chinese : 一次裝置的校準系數
"torque calibration factor" in Chinese : 扭矩校準系數
"transmitter calibration factor" in Chinese : 發射機校準因數
"calibration" in Chinese : n. 1.測定口徑。 2.刻度，標度，劃度數。 3.校準；標準化。
"a olute calibration" in Chinese : 絕對刻度
"absolute calibration" in Chinese : 絕對定標; 絕對法校準; 絕對刻度; 絕對校準
"accuracy in calibration" in Chinese : 標定精度; 校準精度
"accurate calibration" in Chinese : 精確校準
"acoustiocal calibration" in Chinese : 聲學校準
"affine calibration" in Chinese : 仿射校準
"airspeed calibration" in Chinese : 空速表校準
"altimeter calibration" in Chinese : 高度表校準

Examples

Calibration factor of the primary device
一次裝置的校準系數
Calibration factor of a data channel
數據通道校正系數
Main component self - compare with calibration factor can be used when testing impurity content
測定雜質含量時，可采用加校正因子的主成分自身對照法。
Main component self - compare without calibration factor can also be used when there is no impurity reference substance
當沒有雜質對照品時，也可采用不加校正因子的主成分自身對照法。
This calibration factor can be directly recorded under each type for calibrating actual measured peak area of impurities
此校正因子可直接載人各品種項下，用于校正雜質的實測峰面積。
There are three mathematical models of multi - spectral thermometry based on calibration factor , brightness temperature and reference temperature respectively
多光譜輻射測溫法的數學模型有基于檢定常數的數學模型、基于亮度溫度的數學模型和基于參考溫度的數學模型。
You can also formulate corresponding 80 % , 100 % and 120 % of reference substance solutions according to tested items of calibration factors of each type , plus specified amount of internal standard solution to make 3 different density solutions , blend samples for continuous 3 times , and calculate calibration factor
也可按各品種校正因子測定項下，配制相當于80 % 、 100 %和120 %的對照品溶液，加入規定量的內標溶液，配成3種不同濃度的溶液，分別迸樣3次，計算平均校正因子。
When establishing the method , according to stipulations under each type , precisely weigh ( measure ) appropriate amount of impurity reference and component reference under test to formulate solutions testing impurity calibration factor , blend samples and record chromatograph chart , calculate calibration factor of impurity according to above mentioned method ( 1 )
在建立方法時，按各品種項下的規定，精密稱(量)取雜質對照品和待測成分對照品各適量，配制測定雜質校正因子的溶液，迸樣，記錄色譜圖，按上述( 1 )法計算雜質的校正因子。